Bookmark and Share
RSS

Recent Posts

Removable Mass Storage

December 4, 2012

With the October/November announcements, IBM i now supports a new type of removable media. Removable spinning disk (RDX) has become reliable and relatively fast, and can be used as a cost competitive save restore device. Prior to this support, removable media was either Tape or Optical. IBM calls this new type of device Removable Mass Storage (RMS).

RDX cartridges are very reliable, they are ruggedized to withstand a drop from up to 0.9 meters (36 in.) without damage, and they never need cleaning. A cartridge can be placed in either a USB or SATA dock to access the data.

Performance is better than typical for low cost tape drives (DAT), and the SATA device can achieve rates over 180GB/Hr. Chapter 9.31, RDX Device Performance, in the November 2012 Performance Capabilities Reference has the details.

Save/restore operations are done just as with a DVD, for example SAVLIB DEV(RMS01). Because it is an optical class device, you can also use IFS to manage data, e.g. WRKLNK OBJ(‘/QOPT/RDXVOL’). Commands are the normal optical storage commands (WRKOPTVOL, INZOPT, etc.). The IBM i 7.1 Information Center has a new section on Removable Mass Storage (RMS).

Rather than create all new commands, we recognize that the media is random-access and spins, with fixed size physical blocks. That is similar to optical devices, so RMS devices are “optical class” devices to IBM i. RDX Docks are available as CEC installed SATA devices on 6.1.1, or as SATA or USB devices on 7.1 with Technology Refresh 5. Cartridges may be from 320GB to 1TB. Hardware details are available.

IBM i 6.1.1 support reports the dock as a 632A (generic DVD) when directly attached, and as a 632C (virtualized DVD) when a client.

IBM i 7.1 Technology Refresh 5 will report the device as a 63B8 regardless of native attached or virtualized client. This release may host the device, but only to another i partition.

There is no VIOS support for RDX drives.

The external USB devices allow the cable to be unplugged without a configuration change (removing the IOA from the partition, or powering off), but the device should be varied off (VRYCFG) before the device is unplugged.

The announcement material for new I/O features and the developerWorks article on IBM i IO Support Details have additional information.

 

This week’s blog was written by Jim Tilbury who is the lead of the IBM i removable media team. Thanks, Jim!

Posted December 4, 2012| Permalink

Post a Comment

Note: Comments are moderated and will not appear until approved

comments powered by Disqus