Bookmark and Share
RSS

Recent Posts

Subsystem Configuration Documentation

April 18, 2017

Some of you may have read the subsystem configuration experience reports that were written way back in 2004, which was about when V5R3 became available. The experience reports were under the related information section of the Work Management topic. The subsystem configuration experience reports were covered in three sections:
  • Why multiple subsystems are important, along with how to configure subsystems for server jobs
  • How to configure interactive subsystems
  • How to manage server jobs
Each release, these experience reports were brought forward in the Information Center (now the Knowledge Center), but without updates. They were removed from the experience reports section in the IBM i 7.2 Knowledge Center because they had not been updated for years and screenshots of old GUI displays and terminology were outdated.

The good news is that with the 7.3 release, the subsystem configuration information has been updated and incorporated into the Work Management topic within the IBM i Knowledge Center—where it really should have been all along. In addition to updating the existing documentation, the information was also extended to cover the newer IBM i Services for subsystem configuration: SET_SERVER_SBS_ROUTING and SERVER_SBS_ROUTING services.

The screen capture below shows where you will find this topic within the Work Management section in the Knowledge Center.



For easy reference, here are some prior blogs on subsystem configuration, which is clearly a favorite topic of mine.

Subsystem Management with Navigator for i
Route More Work to Subsystems by User Profile
Route Remote Command Requests to a Specific Subsystem
Routing Work to Subsystems
Route DB2 Requests to a Specific Subsystem
Run an HTTP Server in its own Subsystem
Subsystem Configuration for SQL Server Mode Jobs

Posted April 18, 2017 | Permalink

Post a Comment

Note: Comments are moderated and will not appear until approved

comments powered by Disqus